Advertisement
3.
Put the axles on to the alloy landing strut and tighten the 5mm nuts hard against each other. Put
both washers on the inside of the leg to clear the wheel spats. When happy put a small drop of cyno on the
threads near the nuts to stop them coming loose (or use thread lock). Fit the wheel and secure in place
with a wheel collet on either side and make sure the wheel is free to roate. Repeat on both sides.
4.
The landing gear on this model is raked back so be sure to fit the wheel spats on the correct way
round using the 3mx10mm button head screws. Once again make sure the wheel rotates freely. Screw
the landing gear to the fuselgae using the 3mm x 20mm screws and 4 washers, make sure everything is
straight before tightening the screws fully.
6
6
Advertisement
