Advertisement
19.
The holes for the 4 2x10mm self tapping screws are pre drilled in the servo cover, locate them and
use them as a guide to drill 1.5mm holes for the screws to hold the servo hatch/mount in place on the
wing. Repeat For both wing halves.
20.
Insert the aluminium wing spar in to one half of the wing and then push the 2 wing halves together.
Bolt the wing to the fuselage using the large nylon bolts. No glue is required so that the wing can be taken
apart for storage and transport. The last part of the build is to glue the pilot in to the canopy with 5 minute
epoxy and then secure the canopy screen using the M2 x 8mm large head self taping screws, pilot drill the
canopy with a 2mm drill.
21.
Final Setup.
Control throws for first flight.
Aileron
10mm each way
Elevator
8mm each way
Rudder
12mm each way
You can increase these to suit your flying style after
initial test flight are done.
Happy Flying, Mark Tilbury.
Centre of Gravity.
13
13
Advertisement
