Advertisement
1 4
Start your system
IMPORTANT: If you are installing your Profile XP Media Platform as part of an
Open SAN, disregard this step. Instead, follow the instructions in the Open SAN
Instruction Manual for starting your Profile XP Media Platform.
To start your system:
1. Connect power cords to the Profile XP Media Platform and all peripheral devices.
Power
Cord(s)
(115V/230V)
2. Turn on power to all peripheral devices connected to the Profile XP Media Platform.
NOTE: Do not power-on the Profile XP Media Platform until the RAID storage
system is fully initialized. Refer to RAID storage power-up verification steps on
pages 10-15.
3. Turn on the Profile XP Media Platform using the front panel standby switch, and wait
for Windows NT to initialize and perform auto-logon. The Windows NT desktop will
appear after successful auto-logon.
During initialization, the Profile XP system software checks the RAID storage
system for a video file system. Since at first power-up one is not found, an error
message may be displayed regarding loss of the video file system.
Proceed with the next procedure to create a new video file system.
NOTE: You must use the proper power-off sequence when turning off or rebooting
the Profile XP Platform and RAID storage system. Refer to "System power-off and
reboot procedure" on page 6.
23 February 2004
Standard
Power Supply
Optional
Power Supply
Option
RD only
PVS3000 & PVS3500 Installation Guide
0626-14
17
Advertisement
