Advertisement
3
Set up the RAID Storage: PFR700/E
e
3
a
(Local storage only)
Use this diagram to set up the PFR700/E Fibre Channel addresses and to connect
Fibre Channel, Ethernet, and diagnostic cabling.
1
Set Fibre Channel addresses on both
PFR 700 controllers.
0
0
Address ID = 2*
Address ID = 1
*If Installed
Set the same Chassis Address and
2
diagnostic ID on both PFR 700E
Expansion Adapters, if installed.
4 3 2 1 ON
Chassis
ID = "0"
Address = 1
23 February 2004
3
Connect Fibre Channel cabling as shown.
* If Installed
Maximum of 1 Expansion Chassis
PFR 700E*
Expansion
Chassis
PFR 700
RAID
Chassis
This cable and SFP used for PFR 700
with optional RAID Controller 1.
4
Install Ethernet and diagnostic cabling as shown.
Diagnostic cables*
* If Installed
PFR 700E*
Expansion
Chassis
PFR 700
RAID Chassis
IMPORTANT: If you are installing your PVS3000 as part of an Open SAN, do not
perform this RAID storage setup. Instead, follow the instructions in the
Instruction Manual
for setting up RAID storage.
Media Platform
Port A
Port B
Optical SFPs
Media Platform
Ethernet cables
Ethernet Hub or Switch
Open SAN
Connect power cords, and turn on
5
power as shown. You must power-up
the PFR 700E Expansion chassis prior
to, or at the same time as the PFR 700
RAID Controller chassis. Verify power-
up as shown.
Ready
Ready
LED
LED
Power Cords
(115V/230V)
Power-up Verification
Ready LEDs on RAID controllers are steady ON.
Front panel Power LED is ON, Service LED is OFF
after approximately 3 minutes.
Refer to the PFR 700 Instruction Manual if there is a
problem.
Power LED
Service LED
PFR
700
!
POWER
SERVICE
Set up the RAID Storage: PFR700/E (Local storage only)
15
Advertisement
