Advertisement
IMPORTANT: If you are installing your PVS3000 as part of a Media Area Network, do not
perform this RAID storage setup. Instead, follow the instructions in the
Instruction Manual
for setting up RAID storage.
3
Install ethernet cabling and switch or hub as shown.
Maximum of 9 Expansion Chassis
* If Installed
PFR 500E*
Expansion
Chassis
PFR 500E*
Expansion
Chassis
PFR 500
RAID
Chassis
This cable used for PFR500s
with optional RAID Controller B.
Connect power cords, and turn on power as shown.
5
You must power-up the PFR500E Expansion chassis
prior to, or at the same time as the PFR500 RAID
Controller chassis. Verify power-up as shown.
7 Segment
LEDs
Power Cord
HOST RDY
(115V/230V)
12
Set up RAID Storage: PFR500/E (Local storage only)
Open SAN
Media Platform
Ethernet Hub or Switch
Power-up Verification
Rear panel "7 Segment LED" displays the chassis address as
set in step
.
1
All disk drive LEDs are green after approximately 3 minutes.
All HOST RDY LEDs are green after approximately 3 minutes.
Refer to the PFR 500 Instruction Manual if there is a problem.
Disk Drive LEDs
Power Cord
(115V/230V)
3
b
Set up RAID Storage: PFR500/E
(Local storage only)
Use this diagram to connect Ethernet and serial interface cabling required for monitoring the
PFR500/E with NetCentral Lite or NetCentral Manager.
4
Install serial cabling as shown.
Caution: See serial cabling detail below.
PFR 500E*
Expansion
Chassis
PFR 500E*
Expansion
Chassis
PFR 500
RAID
Chassis
This cable used for
PFR500s with optional
RAID Controller B.
After RAID Controller A is configured,
the standard serial cable will be moved
to this connector to configure RAID
Controller B, if installed.
Always plug the first connector
into the PFR500 RAID Controller.
Media Platform
Standard
Serial Cable
Serial Cabling Detail
(Applies to primary and
redundant cabling)
Leave
unconnected
Always plug the end
connector of dasiy
chain cable into last
expansion chassis.
23 February 2004
0626-16
Advertisement
