Operation Of Gas Outflow Protection; Electronic Programmer - Kernau KFC 6008 GE X Operation Manual

OPERATION OF GAS OUTFLOW PROTECTION

The cookers are equipped with the automatic outflow protection system, this system cut the supply
of gas when the flame disappears.
This system prevent from outlflow of gas when the flame on burner will disappears, e.g. when the
burner is primed.
Re-igniting of burner requires user intervention.

ELECTRONIC PROGRAMMER

Setting the current time
After the connecting to power supply system or re-connecting
display shows blinking „0.00".
• Press and hold OK button (or at once </> buttons)
until on display show up
below this symbol will be blinking.
• In 7 sec set the current time using the </> buttons.
After 7 sec from setting the time, new data will be saved, and
the dot will stop blinking.
The time adjustement can be made later by pressing a tonce the </> buttonsm while the dot below the
symbol will be blinking, the current time can be adjusted.
ATTENTION:
The oven can be stared after the symbol show up on display.
The timer
The timer may be stared at any time, without impact on the working process other programator
functions. The adjustment time is from 1 minute till 23 hours and 59 minutes.
To set the timer:
• Press the OK buton, on display will blink „bell" symbol.
• Set the time of timer with </> buttons, the display will show the time of timer and active
work function „bell", after the set time has elapsed the sound signal wil turn on and the „bell"
symbol will blink.
• Press and hold the buttons </> or MENU for turn off the sound signal, the „bell" signal will
disappear, and the display show the current time.
ATTENTION:
Sound singnal will turn off after 7 minutes if no sensors are touched.
symbol, and the dot
OK
Operating mode selection button
OK
Plus button
>
Minus botton
<
Ready to work indicator
Timer indicator
Duration of work indicator
EN 60