Chapter 9. What To Do In Case Of Failure - Kernau KFC 6008 GE X Operation Manual

CHAPTER 9. WHAT TO DO IN CASE OF FAILURE

If any unexpected situation happens, you should:
• Turn the aplliance off.
• Cut off the electrical connection.
• Some small failures can be repaired by the user.
Please follow the instructions below before calling the service:
PROBLEM
Appliance does not work.
The burner does not catch
fire.
The gas igniter does not
work.
The flame is putting out
during the ignition.
Interior illumination does not
work.
The control lamp does not
work.
The oven does not heating.
If the failure was not repaired please cut off the aplliance from power supply system and call the
service. All maintenance and adjustments should be done by qualifed personel only.
CAUSE
Power is cut.
Soiled flame holes.
Power is cut.
Gas is cut.
Soiled gas igniter.
Gas knob is pressed too short.
The gas knob is released to
fast.
Damaged or incorrectly
installed light bulb.
The control lamp turns off
automatically when the
oven reached the setted
temperature.
The function knob and the
thermostat knob was not
setted.
WHAT TO DO
Check indoor fuses.
Cut off the gas inlet, turn the gas
knobs to „0" position, ventilate the
room, remove the burner and clean
the flame holes.
Check indor fuses.
Turn on the gas inlet.
Clean the gas igniter.
Press the knob untill the flame will
not cover the entire ring.
Hold the knob in FULL FLAME
position longer.
Install or replace the light bulb
(see Cleaning and maintance).
(See Control lamps).
Set the knob function, set the
thermostat knob (see Oven Usage).
EN 74