Connection To The Flexible Steel Cable; Connection To The Rigid Pipe Installation - Kernau KFC 6008 GE X Operation Manual

Connector which supplies the gas to the gas cooker it is a threaded connector G ½''.
A. Connection via WZ plug.
Seal
Taper thread
ISO-7-1

CONNECTION TO THE FLEXIBLE STEEL CABLE

In case of installation the gas cooker according to the regulations for class 2, subclass I, for connecting
gas cooker to gas installation it is recommended to use only flexible steel cable, corresponding
to national regulations.
The connector supplies gas to the gas cooker it is a connector with thread ½''. It is recommended to seal
the connection with sealing teflon tape. It is recommended to use only pipes and seals corresponding
to the current regulations. The maximum lenght of flexible steel cable cannot exceed 2000mm.
Make sure if the connection will not touch any other moving elements, which may cause damage.

CONNECTION TO THE RIGID PIPE INSTALLATION

The cooker is equipped with spigot with thread ½''. It is recommended to seal the connection with
sealing teflon tape. The connection to the gas installation should be conducted in way which there is no
tensions in any point of instllation, and on any part of appliance. Use the excessive tightening torque
(greater than 20Nm) or sealing tow can cause joint damage or leakage.
ATTENTION:
If it is necessary to replace the pressure controller during operation, the cooker must have a technical
inspection covering gas valves and gas outflow protection.
Screwed nail
Cylindrical thread
ISO-228-1
WZ plug
B. Connection via a pipe union.
Seal
EN 55
Screwed nail
Cylindrical thread
ISO-228-1
Bottom part
of a pipe union