Chassis Block-2 - Sony TA-ZH1ES Service Manual

TA-ZH1ES
2-4.

CHASSIS BLOCK-2

1 Lift the chassis block in the direction of the arrow
and pull out the back panel of the chassis block
from the hole on the frame (wall) block.
Note 2: When installing the chassis block, take care so that
the DISPLAY board cable does not get caught between
the screw hole on the frame (wall) block and the chassis
block, and between the XLR CONNECTOR board and
the chassis block.
XLR CONNECTOR board
front side
screw hole
frame (wall) block
Pull the DISPLAY board cable in the direction of the arrow.
clamp filter
DIGITAL
board
sheet (POW)
0 Remove the DISPLAY
board cable from the
five wiring stoppers.
4 3.5 JACK board cable
connector (CN011: 7 pin)
5 6.3 JACK board cable
connector (CN004: 7 pin)
6 3.5 JACK board cable
connector (CN003: 6 pin)
8
Note 1: When installing the chassis block, push the cables into
the inside and be careful so that they do not get pinched.
bottom side
Press.
front side
frame (wall) block
front
side
chassis block
frame (wall) block
qf chassis block
slit
7 XLR CONNECTOR board
and 4.4 JACK board cable
connector (CN006: 13 pin)
Press.
slit
top side
3 Open the chassis block
in the direction of the arrow.
qd DISPLAY board
cable connector
(CN100: 2 pin)
qs DISPLAY board
cable connector
(CN603: 9 pin)
qa DISPLAY board
cable connector
(CN604: 8 pin)
qg seal
cushion
qh clamp
filter
(FC1)
8 3.5 JACK board cable
9 Draw the USB MICRO board
cable out of the slit.
chassis block
Press.
2 Pass the USB MICRO board cable
through the slit of the chassis block.
chassis block
hole
back panel
rear side
hole
Attach in order from 1 to 6.
DISPLAY board cable
connector (8 pin)
30 mm
1 clamp filter
2 Wrap the cable
around.
3 close
4 Lock the
two claws.
5 seal cushion
6 Wrap around.
connector (CN010: 8 pin)