Top Panel Block, Frame (Wall) Block - Sony TA-ZH1ES Service Manual

2-5.

TOP PANEL BLOCK, FRAME (WALL) BLOCK

1 Remove the DISPLAY board cable
from the two wiring stoppers.
2 screw
(BVTP3 10)
3 XLR CONNECTOR
board wire with
lug terminal
front side
2 screw
(BVTP3 10)
2 screw
(BVTP3 10)
2 screw
(BVTP3
7 top panel block
front
side
5 DISPLAY board
cable connector
(CN4252: 2 pin)
bottom
8 frame (wall) block
side
2 screw
(BVTP3
3 VOL board wire
with lug terminal
bottom
side
2 three screws
(BVTP3
10)
rear side
top side
4 Open the top panel
block in the direction
of the arrow.
top side
6 DISPLAY board
cable connector
(CN5003: 7 pin)
total eight
screw hole
pillars
rear side
Push the XLR CONNECTOR board
wire with lug terminal to the inside.
10)
front
side
DISPLAY board
10)
CN4002
wiring stopper
Push the wiring stopper to the outer side
to keep the DISPLAY board cable away
from the CN4002.
Note: When installing the top panel block, take care so that the cables
are not pinched at the eight screw hole pillars of the frame (wall)
block and the top panel block.
DISPLAY board
frame (wall)
block
eight screw hole pillars
TA-ZH1ES
Push the wire with lug terminal
toward the screw hole pillar to
keep it away from the S4001.
S4001
CN4003
CN4006
CN4001
– –
Installation
direction
wiring stopper
for the lug
terminal.
top panel block
rear side
screw
hole
pillar
9