Vol Board; Xlr Connector Board, 4.4 Jack Board - Sony TA-ZH1ES Service Manual

TA-ZH1ES

2-10. VOL BOARD

5 bushing (damper)
6 collar (damper)
4 housing (VOL)
boss
2 Remove the VOL board block
in the direction of the arrow.
Note: When installing the VOL
board block, align the
hole and boss.
hole
1 three screws
(BVTP2.6 8)
front side

2-11. XLR CONNECTOR BOARD, 4.4 JACK BOARD

4 XLR CONNECTOR board
Note: When installing the XLR CONNECTOR board,
pull out the wire with lug terminal toward the
rear side.
ire e i
XLR CONNECTOR board
4.4 JACK board
3.5 JACK board wiring stopper
12
3 screw
6 collar (damper)
(BVTP3 10)
7 VOL board
5 bushing
(damper)
6 collar (damper)
2 two screws
(BVTP2.6
wire with lug terminal
bottom side
– Rear view –
3 screw
(BVTP3 10)
5 bushing
(damper)
3 screw
(BVTP3 10)
Not deformed.
rear side
collar (damper)
top side
3 Draw the connector
out of the hole.
8)
rear side
collar (damper)
– –
groove
VOL board
OK NG
Deformed.
collar (damper)
5 two screws
(BVTP2.6 8)
6 Draw the jack out
of the hole.
7 4.4 JACK board
hole
hole
front side
top side
1 Remove the cables of the
XLR CONNECTOR board
and 4.4 JACK board from
the wiring stopper.