Line In Board, Line Out Board, Lpf Board - Sony TA-ZH1ES Service Manual

TA-ZH1ES

2-24. LINE IN BOARD, LINE OUT BOARD, LPF BOARD

8 Draw the LINE OUT board
cable out of the slit.
Note 1: Take care not to damage
the connector and cable.
front side
slit
3 USB A board cable
connector (CN600)
Twist the LPF board
cable three times.
3
2
1
rear side
LINE OUT LPF
board board
qf LINE IN board
Note 4: When installing the LINE IN board,
align the two bosses and two holes.
hole
CN5101
hole
qd connector (CN5406)
Note 3: When removing the connector,
make sure to pull out straight.
Removing at an angle may
damage the connector.
qk LPF board
cable connector
(CN5405)
20
1 LINE OUT board cable
connector (CN002)
bottom side
DIGITAL board
2 LPF board cable
Note 2: When installing the line input/
output jack block to the back
panel, make sure that the
protrusion of the jack root does
not run into the back panel.
CN402
Four protrusions
of the jack root
top side
rear side
ql LPF board
qg connector (CN5404)
boss
Note 3: When removing the connector, make
boss
two bosses
bottom side
qh LINE OUT board
cable connector
(CN5500)
4 AC inlet cable
connector (CN102)
connector (CN402)
7 screw
– Rear view –
sure to pull out straight. Removing at
an angle may damage the connector.
CN5501
hole
hole
qj LINE OUT board
Note 5: When installing the LINE OUT board,
align the two bosses and two holes.
9 Remove the back panel block
in the direction of the arrow.
back panel block
7 screw
6 two screws
(BV/ring)
(L = 8.0 mm)
7 screw
(BVTP3
5 screw
(B3 5)
(BVTP3 8)
rear side
qs line input/output
jack block
qa Draw the jack block
out of the four holes.
hole
two holes
0 four screws
(BVTP3 8)
8)
hole
(BV/ring)
(L = 8.0 mm)