Preparing The Dash; Surface-Mounting The Unit - Enovation Controls MURPHY PowerView Installation Manual

Table of Contents

Advertisement

Installation Kit – P/N 78051451 includes
Mounting Bracket
Gasket/Panel Seal
Seven #8 washers
Seven 8-32 machine screws
Seven 10-32 nuts 3/8"
Six 10-32 1-3/4" machine screws
Tools needed.
Drill with 7/32 in. size bit
Jigsaw
Screw Driver

Preparing the Dash

Determine the location of the PV700 in the dash. Cut a hole in the dash to the
dimensions provided in the cutout templates.

Surface-Mounting the Unit

1. Place the back side of the display through the opening so the display will sit on the face
of the dash.
2. Use the included four long screws and locking nuts from the mounting kit (78051451) to
attach the unit to the bracket.
3. Torque to 10 inch-pounds.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MURPHY PowerView and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Pv700

Table of Contents