FUTABA T16IZ Manual page 39

S.BUS/S.BUS2 device setting
S.BUS/S.BUS2 servos or a telemetry sensor can be connected directly to the T16IZ. Channel setting and
other data can be entered for the S.BUS/S.BUS2 servos or sensors.
S.BUS/S.BUS2
(S.BUS/S.BUS2 servo)
device
WARNING
Do not disconnect or turn transmitter power OFF
while S.BUS servo and telemetry sensor data is
being saved.
■ S.BUS servo and sensor save data will be lost,
39
1. Connect the S.BUS device as shown in the
figure.
2. Turn on the transmitter power.
3. Call the setup screen.
Servo: System Menu → S.BUS servo
Sensor: Linkage Menu → Sensor
4. Perform setting in accordance with each
screen.
5. This sets the channel and other data for each
S.BUS servo, or telemetry device to be used
with the S.BUS device or receiver.
S.BUS/S.BUS2
device
(Telemetry sensor)
resulting in malfunction.
→ GO to TABLE OF CONTENTS