Access Viewing - Pavone Systems DAT 1400 Technical Manual

This menu only appears in case of METRIC functioning.
SUB MENU MESSAGGE
ACC-01
ACC-02
ACCEss ACC-03
ACC-04
ACC-05
PROCEDURE FOR ACCES VIEWING
Press PRG to enter: you will see the operator code used to access the programming of the instrument
and the sequential number of accesses as indicated below:
1d. 0 000
The display shows the ID code used for access (the password table). In the case where access is made
through calibration jumper, it displays the identification code 0000.
Press the PRG key to continue with the visualization of the progressive access number.
Pr. 0 000
The display shows the sequence number of access (this value is incremented at each access and is
never reset). Press the PRG key to exit the access viewing procedure.

ACCESS VIEWING

NAME
Procedure for wiewing last access of
Access 01
Procedure for wiewing last but one access of
Access 02
Procedure for wiewing last but two access of
Access 03
Procedure for wiewing last but three access
Access 04
Procedure for wiewing last but four access of
Access 05
DESCRIZIPTION
authorized personnel.
authorized personnel.
authorized personnel.
of authorized personnel.
authorized personnel.
TYPE
Spc
Spc
Spc
Spc
Spc
Page 57