Cardinal 212G Installation And Technical Manual page 39

SETUP AND CALIBRATION, Cont
If SMA is selected, the data will be transmitted in the following format:
<lf><s><r><n><m><f><xxxxxx.xxx><uuu><cr>
Where:
lf = Line Feed
s = Flags
r = Range
n = Mode
m = Motion
f = Custom
xxxxxx.xxx = Weight
uuu = Units
cr = Carriage Return
*
If SB-400 or Computer is selected, the data will be transmitted in the following format:
<s><xxxxxx><d><uu><m><cc><cr>
Where:
s = Sign
xxxxxx.xxx = Weight
d = Decimal point
uu = Units
m = Mode
cc = Weight Status
cr = Carriage Return
*
The SB-80, SB-300 (multiple displays not supported) and WinVRS use the SB-400 format.
If SB-200 is selected, the data will be transmitted in the following format:
<cr><s><xxxxxx><d><c><uu><m> ETX
Where:
cr = Carriage Return
s = Sign
xxxxxx.xxx = Weight
d = Decimal point
c = status
uu = Units
m = Mode
ETX = End of TeXt
If Rice Lake IQ355 is selected, the data will be transmitted in the following format:
<stx><s>xxxxxxx<u><m><s><cr><lf>
If AnDFV is selected, the data will be transmitted in the following format:
<hdr1>,xxxxx<uu><cr><lf>
8200-M628-O1 Rev A  212G/212GX Installation & Technical
Z= center of Zero, O = Overcap, E = zero Error,
e = weight not currently being displayed
1, 2, 3, ...
G = Gross, T = Tare, N = Net
M = Motion, " "(blank) = no motion
Custom flag
Six digits with decimal point
ton, lb , l/o, oz , t , kg , g
(hex 0D)
"-" = negative, " " (blank) = positive
Six digits
Added to string if enabled in setup
tn, lb, l/o, oz, t, kg, g
G = Gross, N = Net
OC = overcap
CZ = center of zero
MO = motion
ee = weight not currently being displayed
(hex 0D)
(hex 0D)
"-" = negative, " " (blank) = positive
(with leading zeros)
Embedded into weight (after weight dpp
m = motion
o = overcap
e = weight not currently being displayed
tn, lb, l/o, oz, t, kg, g
G = Gross, N = Net
(hex 03) MUST terminate ALL serial commands
=NO
)
Page 35