Adjusting The Cutting Height - pellenc Rasion 2 Smart Operating Instructions Manual

Note
The blades continue to rotate as long as the right trigger (26), used to make the mower move forwards, remains
pressed. This means that you can release the left trigger (30) whilst mowing. When the right trigger (26) is
released, the blades stop rotating at the same time as the mower stops moving.
You can use the mower's motor to move it without turning the cutting blades.

5.2.4. ADJUSTING THE CUTTING HEIGHT

The distance between the cutting blades and the ground can be configured electronically in order to adapt the
cutting height to your needs. There are 6 different settings available at 10 mm intervals from 25 mm at the shortest
to 75 mm at the highest.
Press on the 'menu' button (28) until you reach the cutting
height setting (represented by the letter H).
If necessary, press on the '+' (24) or '-' (22) button to se-
lect the setting of your choice:
• H0: Parking brake/transport brake
• H25: 25 mm between the ground and the cutting
blades
• H35: 35 mm between the ground and the cutting
blades
• H45: 45 mm between the ground and the cutting
blades
• H55: 55 mm between the ground and the cutting
blades
• H65: 65 mm between the ground and the cutting
blades
• H75: 75 mm between the ground and the cutting
blades
Note
If the grass you are mowing is thick, you may need to go over it several times to obtain a uniform cut.
Note
If in doubt about which cutting height to choose, always start mowing with the highest cutting height. Examine
the result on a small area and, if necessary, adjust the cutting height again, being careful not to cut more than
1/3 of the height of the grass.
20
LAWN MOWER RASION 2 SMART
59_143879-B