Table of Contents
Advertisement
Caution
When the optical sensor is covered with dirt, it can no longer analyze the density and the height of the
grass to be cut. The mower stops the cutting blades rotating and a flashing error code is displayed
on the control box.
Warning
Always turn the battery off for maintenance.
Always clean the optical sensor with a cloth soaked in water. Never use a water jet or a solvent!
5.2.3. ADJUST THE CUTTING HEIGHT
The cutting height is adjusted using the handle (15) to select one of six different cutting heights, from 75 mm at the
highest, to 25 mm at the lowest.
Hold the handle (15) firmly whilst simultaneously pressing on
the two buttons to release its position.
Hold the buttons down and move the handle to one of the six
available positions, from 75 mm for the highest cutting height
to 25 mm for the lowest.
Caution
Never work with the mower when the handle (15) is in "parking brake/transport" position.
In this position the cutter housing comes into contact with the rear wheels and acts as a brake. The
mower can therefore neither move forwards nor reverse and cannot be pushed.
Note
If in doubt which cutting height to choose, always start mowing with the highest cutting height. Examine the result
on a small area and, if necessary, adjust the cutting height again, being careful not to cut more than 1/3 of the
height of the grass.
LAWN MOWER RASION 2 EASY
59_141654-A
59N_18_050
21
Advertisement
Table of Contents
