Incidents And Troubleshooting - pellenc Rasion 2 Smart Operating Instructions Manual

Warning
Always clean the optical sensor with water and a wet cloth then turn the battery back on.
Never use solvents!

7. INCIDENTS AND TROUBLESHOOTING

Problem
The lawn mower does
not start
The lawn mower tries
and fails to start
The lawn mower
stops and starts
34
LAWN MOWER RASION 2 SMART
Check
display
display
SEC display
Display
Display
59_143879-B
Probable cause
Battery is off
Battery discharged
Wrong
with the battery
Faulty control
Safety at start up
Cutter deck housing
clogged
Internal fault
Mower safety shut
down (immobilizer)
Cutter deck housing
clogged
The On/Off switches
are defective
Cutter deck housing
clogged
Damaged
cords
Possible action
Switch on the battery
Charge the battery
connection Check the power cord
Check the connec-
tions (tool and bat-
tery).
Clean them with com-
pressed air if neces-
sary
Repeat the operation
if necessary
• Turn the battery off
• Unplug the power
cord and reconnect
it
• Restart the battery
Check that the securi-
ty key is correctly in-
serted
• Turn the battery off
• Clean the inside of
the housing
• Restart the battery
Contact your
proved distributor
Move the mower to
a slope or tilt of less
than 20°
• Turn the battery off
• Clean the inside of
the housing
• Restart the battery
Contact your
proved distributor
• Turn the battery off
• Clean the inside of
the housing
• Restart the battery
power Contact your
proved distributor
ap-
ap-
ap-