Optional Setting And Input / Output Setting Of Indoor Unit - Hisense HYXE-J01H Service Handbook

5.

Optional Setting and Input / Output Setting of Indoor Unit

.
Normal Mode (When unit is not operating)
Change to the optional setting mode.
Press the "CHECK" switch and the "RESET"
switch simultaneously for more than 3 seconds.
Selection of Optional Setting Mode
A/C
SERV.
"SERV." is
Press the "TEMP." ∨ or ∧ switch
indicated and the
and set "01" or "02". Then press
mode number is
the "CHECK" switch.
flashed.
Optional Setting Mode (Mode Number "01")
Selection of Optional Setting Items
A/C
SERV.
A/C
SERV.
In Case of Setting Other Items
Change of Setting Conditions
A/C
SERV.
<Example> When setting 01(Increasing Fan Speed 1)
Refer to the contents of the setting codes for the Table A of "Optional
Setting Items".
Normal Mode
Press the "RESET" switch in the condition of 4 or 5 to cancel the
optional setting mode.
A/C
SERV.
FAN
A/C
SERV.
NOTES: (1) In case that the both indications of the "ADDS." and "RN" show "AA",
Item Code of
Optional Setting
FAN
Select the item code
by pressing the
"TIME"
or
switch.
<Example>
FAN
When selecting C5
(Increasing Fan
Speed)
Setting Condition
The optional setting
condition is changed
FAN by pressing
the "CHECK" switch.
Selection of Indoor Unit for Optional Setting
"01" or "02" fashes.
ADDS
ADDS RNkHR
the same setting is performed to all the indoor units.
(2) The address of indoor unit not connected is not indicated.
Input / Output Setting Mode (Mode Number "02")
Selection of Input / Output Number
A/C
SERV.
A/C
SERV.
�
Refer to Ta le B (Page 8) for contents of the input / output
setting.
In Case of Setting Other Items
Change of Setting Conditions
A/C
SERV.
<Example> When setting 04 (Output: Thermo-ON for Cooling)
Refer to the Table C for the contents of the input / output setting.
Press ∨ or ∧ switch in step 4 or 5 when selecting
settings for another unit.
21
HYXE-F01H
The address of the indoor unit
(ADDS) to set and the refrigerant
cycle number (RN) are indicated
RNkHR
by 0 to 15.(The left figure shows
FAN the No.1 cycle and No.2 indoor unit.)
Select the indoor unit to set by
pressing the " ∨ " or " ∧ " switch
and press the "CHECK" switch.
<Example>
When selecting No.2 cycle and
No.3 indoor unit
FAN
(The address is indicated by 0 to 15.)
Input / Output Number
FAN
Select the input /
output number by
pressing the "TIME"
switch.
or
<Example>
When selecting o1
(Output 1)
FAN
Contents of
Input / Output Setting
The optional setting
condition is changed
FAN
(0→1→2→ ... ) by
pressing the "CHECK"
switch.