Hisense HYXE-J01H Service Handbook page 109

Wireless Receiver Kit
(2) Insert the cable into the rigid metal conduit.
Ｔｈｅ ｉｎｓｔａｌｌ ｏｆ ｅｘｐａｎｄｅｄ ＰＣＢ ｒｅｆｅｒ ｔｏ ｓｔｅｐ （６）．
(3) Fix the fixing bracket of kit by using screw
(Field-Supplied).
(4) Attach the cover same as A-(4).
(Step 1)
Hooking Part
(5)Remove the cover of indoor unit electrical control box and connect the cable to the terminals A and B of
the terminal board (white).
After connecting the cable, bind up the remaining cable length portion by band (Factory-Supplied)
and put them in the electrical control box.
Terminal Board
(White)
Mark Band "A"
NOTES:
Protective box recommend size 99.5 by 92.5 by 35 mm,
fixed hole center is 78 mm.
Receiver panel with transparent plastic protective film,
the official may required removed according to user.
Remove the cover by using slotted screwdriver.
When the back cover installation, to tidy up wiring,
attention to the back cover marked \"switch\"
that justify the board of SW1 switch position
If not according to the requirements of sequenced
operations,may cause install or remove substrate difficulties.
This figure shows the case of Switch Box for 1 Controller.
Box (Field-Supplied)
(Step 2)
Click Sound.
Check to ensure that
cable is not loosen.
Cover
Cable for Wireless Receiver Kit
Example
Ｔｈｅｎ ｉｎｓｔａｌｌ ｔｈｅ ｅｘｐａｎｄｅｄ ＰＣＢ。
Cable
Cable
Screw (Field-Supplied)
Printed Circuit Board
Electrical Box
for Indoor Unit
Mark Band "B"
100