Hisense HYXE-J01H Service Handbook page 150

In Case of 4-Way Cassette Type (Example)
LCD Indication
Approx.
Air Louver Angle
25
COOL and DRY
HEAT
NOTES:
# The fi xing angle of the louver shown above is the case of 4-way cassette type indoor unit. The fi xing angle is
different according to unit model. Refer to the operation manual of each model for details.
#There exists a time lag between the indicated louver position on LCD and the actual louver angle in operation.
Therefore, when fi xing the louver, set the angle according to the indicated louver angle on LCD.
#When the "AUTO LOUVER" switch is depressed, the louver may not stop immediately.
ATTENTION:
The louver angle is automatically changed during heating operation for unit control.
• When heating operation is started
• When dry operation is started
• When temperature controller is activated
The LCD indication remains at the setting condition.
D. Unit Operation
1. Depress the "ZONE" switch and "GROUP" switch and select the
setting target.
(Refer to item 2 of "A. Setting Target Selection and Monitoring
Unit Operation Status" .)
2.Depress the "RUN/STOP" switch.
In case that the selected group is in operation, the group is
stopped by depressing "RUN/STOP" switch.
In case that the group is not in operation, the group is
started by depressing the "RUN/STOP" switch.
In case of setting target group "AA", depress the "RUN/STOP"
switch, and;
a. All indoor units are stopped (When more than 1 group is in
operation (Run lamp is ON)).
b. All the groups are started operation (When all the groups are
stopped (Run lamp is OFF)).
NOTES:
#The above indications show the case of setting operation mode for "ZONE 3, GROUP 6".
#The same setting procedure shall be performed for other groups. In case of the simultaneous operation for all
groups, select the group number of "AA".
Approx. Approx.
o o
30
Recommnended
Angle
The louver angle
is automatically
changed.
Approx.
o o
35 40
Angle Range
Angle Range
When the discharge air temperature is
increased over 30
automatically return to the set position.
The above fi gure shows the case of selecting
"ZONE 3, GROUP 6".
The above fi gure shows the case of "ZONE 3,
GROUP 6" operation.
141
Approx. Approx.
o o
50 55
Recommnended
Angle
o
C, the louver angle
Turned ON
HYJE-D02H
Approx.
o
60