About Zone And Group; About Setting Target - Hisense HYXE-J01H Service Handbook

About Zone and Group

The central station controls plural indoor units as a unit (one indoor unit is also available).
The operation unit is as follows;
Group...........................................Minimum Operation Unit for Central Station
Zone ............................................Operation Unit Consisting of Plural Groups
Remote Control Switch Group .....Operation Unit Consisting of Plural Indoor Units Connected with Transmission Line
!Confi guration of Zone and Group
All Units
For checking the contents of the setting for zone and group, use the "Zone and Group Setting Table of Central
Station (2)" in page 15.

!About Setting Target

The zone and the group subject to setting and monitoring are called as setting target. The central station indicates
the setting target as shown below.
Indication Example 1
This indication is the example in the case where the
setting target is group.
The setting of the selected group is ordered.
Indication Example 2
This indication is the example in the case where the
setting target is zone.
The setting of all the groups set in the selected zone is
ordered.
Indication Example 3
This indication is the example in the case where the
setting target is all the indoor units.
The setting of all the units (all the groups) set is ordered.
One remote control switch group is considered as one group under the same
control.
The central station can control up to 64 groups (4 Zones x 16 Groups).
Up to 16 groups can be set in one zone.
The central station can control up to 4 zones.
of Remote Control Switch
In the remote control switch group, the indoor units are under the same control
setting.
Zone 1
Zone 2
Zone 4
137
Group 1
Group 16
Group 1
Group 16
(ex. In case of Zone 1 and Group 2)
(ex. In case of All Group in Zone 1)
(ex. In case of All Indoor Units)
HYJE-D02H
Ref.1 - No.1 I.U.
Ref.1 - No.2 I.U.
Ref.2 - No.1 I.U.
SET TEMP.
SET TEMP.