Displaying The List Of Waypoints; Specifying The Map Settings; Opening The Map Settings; Map Settings - Bosch Center CM-C 19 Operating Instructions Manual

56 | en
All route sections between the two selected
sections are blocked.
f Tap Recalculate route.
The route is recalculated and displayed in the
map view.
Note:
Tap to cancel the operation. You
will return to the Destinations menu.
Unblocking blocked route sections
You can unblock route sections that you previ-
ously blocked.
f In the Route menu, tap Unblock route list.
The route is recalculated and displayed in the
map view.
10.9.2 Map settings
1 menu level 2 menu level
st nd

Map settings

Map view
Guidance view
Show POIs on map
More options
10.8.8 Displaying the list of
waypoints
f In the Route menu, tap Waypoints.
The waypoints and destination of the active
route guidance session are displayed.
f Tap an item to view the details for the respec-
tive waypoint/destination (see the section
entitled "Location details view" (page
51)).
10.9 Specifying the map settings
With the map settings you can specify map view
options.
10.9.1 Opening the map settings
To adjust the map settings,
3 menu level Function
rd
2D map You can switch between the normal 2D view from above and the 3D map
view (perspective view). In addition, you can select the split screen
Split 2D map
mode for both view modes. In split screen mode, information about the
3D map
next driving manoeuvre is emphasized on the left side of the screen.
Split 3D map
f Tap the desired option.
Full map
f Tap the desired option.
Intersection
Accommodation
Select the POI categories to be displayed on the map.
:
f Tap the desired option to turn it on or off.
Transport
See next section.
f in navigation mode, touch the tab at the
bottom of the screen.
f Tap the button.
The navigation settings are displayed.
f Tap Map settings.
Notes:
f To scroll through the available set-
tings, touch the list area and swipe
up or down.
Tap to return to a higher menu
f
level or to leave the menu.
Navigation