Displaying Tmc Messages; Changing The Displayed Section Of The Map; Viewing Details Of A Location On The Map; Selecting A Point Of Interest From The Map - Bosch Center CM-C 19 Operating Instructions Manual

54 | en
and whether
a 2D map is shown or
f
a 3D map is shown.
f
f In the map view, tap the compass (11) to
switch between these modes:
– 3D map aligned with the driving direction
– 2D map aligned with north
– 2D map aligned with the driving direction
Notes:
You can also change the map orien-
f
tation in the map settings (see the
section entitled "More map setting
options" (page 57)).
You can also activate the 3D map
f
view in the map settings (see the
section entitled "Map settings"
(page 56)).
10.7.6 Displaying TMC messages
f In the map view, tap the TMC symbol (1).
A list containing the current TMC messages is
displayed.
Note:
While a route guidance session is
active, you have these options:
f Tap On route to display only mes-
sages that concern your current
route.
Tap All to display all current mes-
f
sages.
f Tap on a message to display details about this
message.
10.7.7 Changing the displayed
section of the map
During active route guidance, you can choose
whether
f the map should show the entire route or
whether
the map should show the area around the
f
vehicle.
f In the map view, tap the button (3) to switch
between the modes.
10.7.8 Viewing details of a location
on the map
f Tap the location on the map.
f Tap Details.
The details view of the location is displayed (see
the section entitled "Location details view"
(page 51)).
10.7.9 Selecting a point of interest
from the map
You can select a point of interest from the map
or search for points of interest near a location on
the map. Then you can view the details of a point
of interest and set it as your destination, if
desired.
To view details of a particular point of interest,
f tap the symbol of the point of interest on the
map.
The details view of the location is displayed (see
the section entitled "Location details view"
(page 51)).
Note:
If you long tap a point on the map
where several symbols overlap, a list of
the corresponding points of interest is
displayed. Select the desired point of
interest from the list.
To search for points of interest near a location
on the map,
f tap the location on the map.
f Tap POIs around.
The available point of interest categories are
displayed. Continue reading the section entitled
"Selecting a point of interest and starting route
guidance" (page 49).
10.8 Route guidance settings in the
Route menu
10.8.1 Opening the Route menu
Note:
The Route menu is only available when
a route guidance session is active.
f Tap the title bar of the navigation tile in the
home menu.
Navigation