Further System Settings - Bosch Center CM-C 19 Operating Instructions Manual

Operation
4.8 Further system settings
To adjust the system settings,
f If necessary, first call up the home menu for
the cockpit.
f Touch the tab at the bottom of the screen.
f Tap the button.
The system settings are displayed.
f Tap the desired option.
1 menu level 2 menu level
st nd
:
Unit of measurement Imperial
Metric
Lock keypad while
driving
Open source soft-
ware
Reset to factory Center CM-C 19
settings
:
<Component N>
Software version Center CM-C 19
:
<Component N>
Data carrier version
Serial number
Software update
Notes:
f To scroll through the available set-
tings, touch the list area and swipe
up or down.
Tap to return to a higher menu
f
lever or to leave the menu.
3 menu level Function
rd
The device can use the metric or imperial unit of measurement.
f Tap the desired option.
Set whether keypad should be disabled while the vehicle is moving. If
the speed lock is activated, you will only be able to use keypads while
the vehicle is stationary.
f Tap Lock keypad while driving to turn on/off this option.
View information about and software licenses of the open-source soft-
ware used by the device.
f Tap this option.
f Tap the desired system component to start resetting.
Note:
If the Center CM-C 19 is a stand-alone unit, you don't enter the 2
level. Tap
View the currently installed software version of the system components.
f Tap the desired system component to view possible error messages.
View the version of the installed map data.
View the serial number of the device.
See the following section "Software update".
to confirm and start resetting.
en | 21
menu
nd