Usb Storage Device/Apple; Connecting A Device Via Bluetooth - Bosch Center CM-C 19 Operating Instructions Manual

Operation
WMA
f Codecs
– WMA 9
– WMA 10
Bitrates
f
– 5 kBit/s to 384 kBit/s with VBR/CBR
f Sample rates:
– 8 kHz to 48 kHz
4.10.2 USB storage device/Apple
General information
The external devices connected to the USB
f
port must comply with the USB Mass Storage
Class specification (USB MSC).
Devices connected via USB are supported
f
according to USB specification V 2.0.
Devices with USB specification 1.0 and 3.0
are compatible.
Hard Disk Drives (HDD) are not generally
f
supported.
f USB hubs are not supported.
Connecting and removing a USB storage device
or Apple device
To connect a USB storage device or Apple
device,
f connect it to the USB port.
A notification appears briefly in the display
when the device detects the USB storage device
or Apple device.
To remove a USB storage device or Apple
device,
f pull it out of the USB port.
An appropriate notification appears briefly in
the display.
4.10.3 Connecting a device via
Bluetooth®
Notes:
f You can connect up to two BT
devices to the device.
f The procedures described in this
chapter apply to Bluetooth® mobile
phones as well as to Bluetooth®
audio streaming devices such as a
Bluetooth® MP3 player.
General information
The device supports Bluetooth® 4.2 and the
following Bluetooth® profiles and standards:
f A2DP 1.3
AVRCP 1.6
f
HFP 1.6
f
f MAP 1.1
f PBAP 1.1
f SPP 1.1
Vcards 2.1, 3.0
f
Turning Bluetooth on/off
f If necessary, first call up the home menu for
the cockpit.
f Tap the bottom menu tab and then tap the
button.
f Tap Switch on Bluetooth.
Bluetooth is turned on when the check mark is
displayed in the checkbox.
f Tap to leave the menu.
en | 25