Table of Contents
Advertisement
Signal Processor
5
Language Selection
The Landmark Graphic GS processor can be set up to display text in either
English, German, Italian, French, Spanish or Japanese. The processor is
supplied set up to display in English.
Changing the language setting involves removal of the back panel, therefore
it is recommended that the language is selected before installing the
processor in a panel.
(i) To change the language setting, first unscrew the six screws on the back
panel of the processor. Refer to Fig. 10.
(ii) If a serial communications board is fitted, remove it.
(iii) Remove the power supply assembly (on right hand side) and slide out as
many of the thermometer channel boards as necessary to gain access to
the language selector switch.
The language selector switch, on the rear of the front panel assembly, is now
revealed. See Fig. 36.
Page 46
Fig. 36 - Location of language selection switch
(F)
(1)
(3)
(D)
(B)
(5)
(7)
(9)
LMG GS
User Guide
238036
Advertisement
Table of Contents
