Using The Processor - Ametek Land LMG GS User Manual

User Guide
3

Using the Processor

Once the processor has been installed in its chosen location, it must be connected
to the appropriate thermometer(s) and to a suitable a.c. power supply.
Ensure that the supply voltage setting switch, located on the rear panel of the
processor, is set to correspond with your processor power supply.
When the processor is first connected to a thermometer, the processor must be
configured for use with that thermometer. Electrical connections to and from the
processor are made on the rear panel. The temperature measurement system
(i.e. processor and thermometer) is configured via the processor menu system
using the keys on the front panel. The location of the processor controls is given
in Fig. 16. An overview of the System 4 and GST I/O card menu systems is given
in Fig. 17 and 18 respectively.
1 Front display panel
2 Emissivity adjustment 'quick key'
3 Alarm adjustment 'quick key'
4 Display selector 'quick key'
LMG GS
Fig. 16 - Front panel display and controls
5 Cursor 'up' key
6
Cursor 'down' key
7
'Enter' key
Signal Processor
1
2
3
4
5
6
7
238016
Page 23