Table of Contents
Advertisement
Signal Processor
Ensure cable outer insulation
is held in clamp bar/cable tie
Fig. Wiring arrangement for System 4 Thermometer cable connector
2.4 GST Thermometer Cable Connector Assembly
The cable connectors for the rear panel of the processor are included in the
processor package. Each cable connector must be correctly wired with the
appropriate cable before the processor is used (refer to Section 2.2 for the
cable schedules).
To wire up the connector.
(i)
Make a note of the connector's orientation in the rear panel of the processor.
(ii)
Wire up the connector, remembering the correct orientation of the plug, in
accordance with the relevant cable schedule (see Section 2.2). Refer to Fig. 14a.
NOTE
Keep wire length as short as possible.
The connector is now ready for use.
Page 20
Clamp bar
Keep wire length as
short as possible
1
7
User Guide
238014
LMG GS
Advertisement
Table of Contents
