Ametek Land LMG GS User Manual page 17

User Guide
(v) From the rear, re-insert the clamp bars into their channels and push
them up to touch the mounting panel.
(vi) Insert and tighten the retaining screws until the mounting panel is firmly
gripped between the processor front panel and the clamp bar.
CAUTION
Do not overtighten the screws as this will deform the clamp bar.
LMG GS
Retaining screw
Fig. 3 - Mounting the processor into a panel
Clamp bar
Signal Processor
Viewing side
Mounting panel
238003
Page 9