Connections & Operations - Launch X-431 PAD VI User Manual

LAUNCH
• In the Device S/N column, choose the desired SmartLink C Serial Number from the pull-down list if
several SmartLink C is bound to the current account.
• In the Vehicle information column, enter the VIN manually and choose the right Make, Car model,
Model year, Displacement, Engine type and Function.
Note: In general, vehicle identification numbers are standardized - all contain 17 characters. VIN characters
may be capital letters A through Z and numbers 1 through 0; however, the letters I, O and Q are never used in
order to avoid mistakes of misreading. No signs or spaces are allowed in the VIN.
• In the Contact information column, input the phone number, E-mail address and name so that you can
be reached by the remote SmartLink B in the shortest time.
• In the Problem Description input box, it is highly recommended to describe the vehicle failure as
accurate as possible because it is very helpful for the SmartLink B to have a general understanding of
the vehicle status.
• Tap Link Platform Register Protocol to read it carefully. After reading it, select the checkbox I agree.
3. After filling the information, tap Submit to create the order.
On-screen buttons:
• View details: Double check if the order information is correct or not.
• Review: rates the service that has been already finished.
4. Next refer to Chapter 8.2.2 to make connections and start the diagnosis.
Note: The remote SmartLink operation can only be performed after the SmartLink C has submitted the request,
and this request has been accepted by the remote SmartLink B.
8.2.2 Connections & operations
Follow the steps below to proceed:
1. Turn off the vehicle ignition.
2. Connect one end of the OBD II extension cable into the OBD-16 diagnostic port of the SmartLink C
42
PAD VII User Manual
www.x431.com +86 755 8455 7891