Launch X-431 PAD VI User Manual page 49

LAUNCH
device, and the other end into the vehicle's DLC port.
Note: During the SmartLink diagnosis, especially during remote online programming, it is recommended that
the vehicle battery is connected to a charging power source. Doing so can prevent the vehicle from running out
of power and failing to start due to long diagnosis time.
3. Plug one end of CAT-6 crossover cable into the LAN/WLAN port of the SmartLink C device, and the other
end into the LAN port of network modem.
Note: The network broadband of 100MB and above is required for this operation.
4. After a successful network connection, the SmartLink C screen displays prompt information asking
whether to enter the super remote diagnostic mode. Tap Yes, the system will automatically read the
vehicle information and connect to the remote diagnosis server.
Note: One SmartLink C can only accept one remote diagnostic operation at one time.
5. Turn on the vehicle ignition.
Note: After receiving the order, the SmartLink B master technician will accept the order and contact you via
phone or E-mail address.
6. After a successful connection between the SmartLink C and SmartLink B is established, the following
message will be displayed on the SmartLink C screen.
www.x431.com +86 755 8455 7891
PAD VII User Manual
43