Chapter 4. Setting Of Software; Open Software - Novusun CNC NC200 Manual

Chapter 4.

4.1 Open software

Double-click the mach3mill
Enter mach3 software. Pop-up the plug-in dialog box. See as Figure 4-1.
Choose our plugin NC200_Novusun-PlugIn---Ver-
to the dialog box appear again next time, you can select Don't ask me this again.If connect
successfully,Status bar will show "NC200 device is connected to your computer". See as
Figure4-2.
Manual of NC200
Setting of software
。
Figure4-1. Plugin selection dialog
2.0a Then press OK. If you do not want
- 14 -
www.nvcnc.net
。