CAME KIT AGT V + LITHOS Installation Manual page 14

M1
BOUT
M1
BOUT
M1
BOUT
M1
BOUT
PROG
<1'' <1''
PROG
M2
SW3
M2
SW3
PROG
PROG
M2
SW3
PROG
PROG
M2
SW3
Exiting programming. Press the PROG key briefl y
PROG LED will switch off .
NOTE. If no action is performed, the procedure will end automat-
ically after 30 minutes.
Programming type of keys. When "Programming call keys",
press and hold the PROG key
>3'' >3''
release it (within 6 seconds) as soon as the PROG LED lights up
and the key backlighting fl ashes as shown in fi gure
<6'' <6''
the "Programming type of keys" procedure.
Press and hold the fi rst key on the entry panel in the position
shown until the LED backlighting stops fl ashing and remains
on .
To exit programming once complete, press the PROG key briefl y
. The PROG LED will switch off .
If no action is performed, the procedure will end automatically
after 30 minutes.
for at least 3 seconds, then
M1
BOUT
. The
, entering