CAME KIT AGT V + LITHOS Installation Manual page 12

M1
A
M1
M2
M1
BOUT
PROG
<1'' <1''
PROG
M2
SW3
SW3
Programming type of keys. Press and hold the fi rst key on the
entry panel in the position shown
lighting stops fl ashing and remains on
M1
BOUT
Programming the call keys. Lift the receiver
you want to program (where present), then press the door lock
release button and AUX2 button
On the entry panel, press the call key to be associated with the
receiver . A beep will confi rm that the setting has been stored.
Reposition the handset where applicable
operations for all the other receivers.
Exiting programming.
Briefl y press the PROG key
NOTE. If no action is performed, the procedure will end automat-
ically after 30 minutes.
/ A until the LED back-
.
PROG
PROG
M2
SW3
handset that
.
and repeat the same
. The PROG LED will switch off .
beep beep