Connect Discharge Hose (Optional) - Briggs & Stratton Water Transfer Pump Operator's Manual

3. Slide hose clamp (A) over end of hose (B). Slide
suction hose onto hose barb (C). Tighten hose clamp
securely using a standard 1/4" (6mm) screwdriver.
C
A
B
Attach Suction Hose to Strainer Basket
Slide hose clamp over hose. Attach open end of suction hose
to strainer hose barb. Tighten hose clamp securely using a
standard 1/4" (6mm) screwdriver.

Connect Discharge Hose (Optional)

If desired, use a commercially available hose. DO NOT use a
hose with an inside diameter smaller than the pump's
discharge port size.
1. Slide barb cuff over hose barb. Insert rubber seal into
end of barb cuff as shown earler.
2. Screw hose barb assembly onto pump in clockwise
rotation until hose barb assembly is tightened securely.
3. Slide hose clamp over end of discharge hose. Slide
discharge hose onto hose barb. Tighten hose clamp
securely using a standard 1/4" (6mm) screwdriver.
9