B0003306 / Rev. 1.0
8
Maintenance
Pos: 44 /Doppelblech/Geräte/R100/10 Wartung/Allgemein A100 @ 0\mod_1184851819781_501.doc @ 4165
Due to the use of a permanent magnet inside the sensor, chips and metal particles can accumulate
at the sensor. Thus the sensor must be cleaned from time to time.
In case of heavy abrasion the sensor can wear out. It must be replaced, if the sensor face begins to
show small punctures.
A sensor and a sensor cable should be kept on stock as spare parts.
When ordering spare parts, always state the serial number, the order information and the part
number (if available).
Pos: 45 /Komponenten allgemein/Leerseite @ 0\mod_1165223317234_501.doc @ 2343
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Manual
Double Sheet Detector R100-Serie A100
for single sided sensors
Maintenance
35