Dell EMC PowerEdge R440 Installation And Service Manual page 109

Figure 113. Installing the system board
Next steps
1. Replace the following:
a. Install the Trusted Platform Module (TPM).
b. Internal PERC riser
c. Internal USB key (if applicable)
d. USB 3.0 module (if applicable)
e. IDSDM/vFlash module card
f. All expansion cards and risers
g. Processors and heat sink modules
h. Processors blanks (if applicable)
i. Memory modules
j. LOM riser card
k. Air shroud
2. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Follow the procedure listed in
4. Ensure that you:
a. Use the Easy Restore feature to restore the Service Tag. For more information, see the
using the Easy Restore feature
b. If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see
the Restoring the Service Tag by using the Easy Restore feature
c. Update the BIOS and iDRAC versions.
d. Re-enable the Trusted Platform Module (TPM). For more information, see the
section.
5. Import your new or existing iDRAC Enterprise license.
For more information, see Integrated Dell Remote Access Controller User's Guide, at
Restoring the system using Easy Restore
The easy restore feature enables you to restore your service tag, license, UEFI configuration, and the system configuration data
after replacing the system board. All data is backed up in a backup flash device automatically. If BIOS detects a new system
board, and the service tag in the backup flash device, BIOS prompts the user to restore the backup information.
Before working inside your
section.
system.
section.
Upgrading the Trusted Platform Module
Installing and removing system components
Restoring the Service Tag by
www.dell.com/poweredgemanuals
109