Control Panel; Removing The Left Control Panel - Dell EMC PowerEdge R440 Installation And Service Manual

Figure 105. Installing power interposer board
Next steps
1. Install the PSU.
2. Install the air shroud.
3. Follow the procedure listed in

Control panel

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3. Remove the air shroud.
4. Remove the internal PERC riser.
Steps
1. Disconnect the control panel cable from the system board connector.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
2. Using a Phillips #1 screwdriver, remove the screws that secure the cable cover.
After working inside your system
Safety instructions.
Before working inside your system
on page 26.
on page 26.
Installing and removing system components 103