Dell EMC PowerEdge R440 Installation And Service Manual page 16

Table 11. Back view of the system with full height riser (continued)
Item Ports, panels, or slots
10 System status indicator
cable port
11 System identification
button
Figure 10. Back view of the system with 2 risers
Table 12. Back view of the system with 2 risers
Item Ports, panels, or slots
1 Serial port
2 iDRAC9 dedicated
network port
3 Ethernet ports (2)
4 Low profile riser right slot N/A
5 Low profile riser left slot
6 Cabled PSU
7 LOM riser ports (2)
8 USB 3.0 port (2)
9 VGA port
16 Dell EMC PowerEdge R440 system overview
Icon Description
N/A Enables you to connect the status indicator cable and view system
status when the CMA is installed.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for more than 15
seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
● If the system stops responding during POST, press and hold
Icon Description
Use the serial port to connect a serial device to the system. For
more information, see the PowerEdge R440 Technical Specs at
www.dell.com/poweredgemanuals
NA
Use the iDRAC9 dedicated network port to securely access the
embedded iDRAC on a separate management network, see the
Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals
Use the Ethernet ports to connect Local Area Networks (LANs) to
the system. For more information, see the PowerEdge R440
Technical Specs at
Use the card slot to connect half-height PCIe expansion card on
low profile riser.
N/A Use the card slot to connect half-height PCIe expansion card on
low profile riser.
N/A FFor more information, see the PowerEdge R440 Technical Specs
at www.dell.com/poweredgemanuals
For more information, see the PowerEdge R440 Technical Specs at
www.dell.com/poweredgemanuals
Use the USB 3.0 port to connect USB devices to the system.
These ports are 4-pin, USB 3.0-compliant.
Use the VGA port to connect a display to the system. For more
information, see the PowerEdge R440 Technical Specs at
www.dell.com/poweredgemanuals
button is enabled in the iDRAC setup.
the system ID button (for more than five seconds) to enter
the BIOS progress mode.
www.dell.com/poweredgemanuals
.