Installing The Left Control Panel - Dell EMC PowerEdge R440 Installation And Service Manual

Figure 106. Removing the cable cover
3. Using a Phillips #1 screwdriver, remove the screws that connect the control panel to the system.
Figure 107. Removing left control panel
4. Holding by the sides, remove the left control panel assembly away from the system.
Next steps
Install the left control panel.

Installing the left control panel

Prerequisites
Follow the safety guidelines listed in
Steps
1. Route the control panel cable through the side wall of the system.
2. Align the left control panel assembly with the control panel slot on the system and place the assembly in the slot on the
system.
3. Connect the control panel cable to the system board connector.
4. Using Phillips #1 screwdriver, install the screws that secure the cable cover to the system.
104 Installing and removing system components
Safety instructions.