Initializing Tpm For Bitlocker Users; Initializing The Tpm 1.2 For Txt Users - Dell EMC PowerEdge R440 Installation And Service Manual

Figure 114. Installing the TPM
Next steps
1. Install the system board.
2. Follow the procedure listed in After working inside your system on page 26.

Initializing TPM for BitLocker users

Steps
Initialize the TPM.
For more information, see .
The TPM Status changes to Enabled, Activated.

Initializing the TPM 1.2 for TXT users

Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
3. From the TPM Security option, select On with Pre-boot Measurements.
4. From the TPM Command option, select Activate.
5. Save the settings.
6. Restart your system.
7. Enter System Setup again.
8. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
9. From the Intel TXT option, select On.
112 Installing and removing system components