Feig Electronic OBID i-scan ID ISC.M02 Installation Manual page 5

®
OBID i-scan HF
1 Safety Instructions / Warning - Read before start-up !
•
The device may only be used for the purpose intended by the manufacturer.
•
The operation manual should be kept readily available at all times for each user.
•
Unauthorized changes and the use of spare parts and additional devices which have not been
sold or recommended by the manufacturer may cause fire, electric shocks or injuries. Such
unauthorized measures shall exclude the manufacturer from any liability.
•
The liability-prescriptions of the manufacturer in the issue valid at the time of purchase are valid
for the device. The manufacturer shall not be held legally responsible for inaccuracies, errors,
or omissions in the manual or automatically set parameters for a device or for an incorrect
application of a device.
•
Repairs may only be undertaken by the manufacturer.
•
Installation, operation, and maintenance procedures should only be carried out by qualified
personnel.
•
Use of the device and its installation must be in accordance with national legal requirements
and local electrical codes .
•
When working on devices the valid safety regulations must be observed.
•
Before touching the device, the power supply must always be interrupted. Make sure that the
device is without voltage by measuring. The fading of an operation control (LED) is no indicator
for an interrupted power supply or the device being out of voltage!
•
Special advice for wearers of cardiac pacemakers:
Although this device doesn't exceed the valid limits for electromagnetic fields you should keep
a minimum distance of 25 cm between the device and your cardiac pacemaker and not stay in
the immediate proximity of the device's antenna for any length of time.
FEIG ELECTRONIC GmbH
Installation
Page 5 of 27
ID ISC.M02
M20301-4e-ID-B.doc