Configuring Additional Platform Daemon Users - LG niagara4 MultiSITE Edge 10 User Manual

Replacing the factory-default platform user
You see this dialog only in the initial commissioning of a new MS-E10 device, or possibly at some future point after installing a
"clean dist" file.
Figure 23: Platform daemon
Step 1 In the User Name field, type in the desired user name for platform login.
Step 2 In the Password fields, type in a strong password (it must match in both password fields). Password must use a
minimum of 10 characters including: at least one uppercase character, at least one lowercase character, and at least one digit.
Step 3 In the (optional) Comment field, you can enter an alphanumeric descriptor for this platform admin user, where it is seen
in the "Users table" if there are more than one platform user.
Step 4 Click the Next button. You proceed either to the final commissioning (review changes) step, or if you selected to
configure additional platform daemon users, you see your replacement user in the Users table of the Platform Daemon
Authentication dialog.

Configuring additional platform daemon users

This step in the Commissioning Wizard lets you add additional platform admin users in the MS-E10 device, and also delete users
and change passwords. Platform daemon authentication lets you create up to 20 (total) additional platform admin users.
Figure 24: Platform daemon authentication
You can access this same window via the User Accounts button in the Platform Administration view, available any time after
commissioning.
Step 1 Click New User for the popup New User dialog, as shown above.
Step 2 In the User Name field, type in the desired user name for platform login.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
MS- E10 User Guide
37