Bleed Fuel Supply System; Adjust; Front Headlights - Manitou MC 18-2 D K ST3A S1 Operator's Manual

BLEED
These operations are to be carried out only in the following cases:
• A component of the fuel system replaced or drained.
• A drained tank.
• Running out of fuel.
Ensure that the level of fuel in the tank is sufficient and bleed in the following order:
BLEEDING THE FUEL FILTER
- Open the engine cover (
INSTRUMENTS).
- Unscrew bleeder screw 1.
- Switch on the lift truck ignition until the diesel fuel flows from the bleeder screw
free of any air.
- Tighten the bleed screw while the diesel fuel is flowing out.
BLEEDING THE INJECTION PUMP
- Open bleed screw 2.
- Switch on the lift truck ignition until the diesel fuel flows from the bleeder screw
free of any air.
- Hermetically close the bleed valve while the diesel fuel is flowing.
The engine is now ready to be started.
NOTE: If the engine runs correctly for a short time then stops or runs erratically, check
for possible leaks in the low pressure circuit. If in doubt, contact your dealer.

ADJUST

RECOMMENDED SETTING
(as per standard ECE-76/756 76/761 ECE20)
Adjustment of -2 % of the dipped beam relative to the horizontal
axis of the headlight.
ADJUSTMENT PROCEDURE
- Place the unladen lift truck in the transport position and
perpendicular to a white wall on flat, level ground.
- Check the tyre pressures (
- Place the forward/reverse selector in neutral.
CALCULATING THE HEIGHT OF THE DIPPED BEAM (H2)
• h1 = Height of the dipped beam in relation to the ground.
• h2 = Height of the adjusted beam.
• I = Distance between the dipped beam and the white wall.
2 - DESCRIPTION: CONTROL AND COMMAND

Front headlights

2 - DESCRIPTION: TYRES).
3 - 34
Fuel supply system
h2 = h1 - (l x 2 / 100)
h1
+%
-%
h1
h2
l
www.duma-rent.com
1
2