Replace; Battery - Manitou MC 18-2 D K ST3A S1 Operator's Manual

FRONT WHEEL
- Lift the carriage and tilt the mast backwards.
- Immobilize under the foot of the mast on the side where the wheel is being changed.
- Tilt the mast forwards to lift the wheel.
- Place wedges under the chassis as near as possible to the wheel.
- Completely unscrew the wheel nuts and remove them.
- Free the wheel by reciprocating movements and roll it to the side.
- Slip the new wheel on the wheel hub.
- Hand-tighten the nuts, grease them if necessary.
- Remove the wedges under the axle and lower the lift truck.
- Tighten the wheel nuts with a torque wrench (
EVERY 2000 HOURS OF SERVICE OR EVERY 4 YEARS) for tightening torque.

REPLACE

Handling and servicing a battery can be dangerous; take the following precautions:
- In the event of electrolyte being spilled onto the skin or splashed in the eyes, rinse thoroughly
with cold water for 15 minutes and call a doctor.
- Open the access cover 1.
- Unscrew the battery fastener 2.
- Disconnect terminal 3 (+) then terminal 4 (-).
- CHANGE THE BATTERY
2000H - PERIODIC MAINTENANCE -
IMPORTANT
- Wear protective goggles.
- Keep the battery horizontal.
- Never smoke or work near a naked flame.
- Work in a well-ventilated area.

Battery

3 - 33
www.duma-rent.com
1
4
3
2