Manitou MC 18-2 D K ST3A S1 Operator's Manual page 80

Lift truck
Hide thumbs Also See for MC 18-2 D K ST3A S1:
Table of Contents

Advertisement

1000H - ROUTINE MAINTENANCE - EVERY 1000 HOURS OF SERVICE OR 2 YEARS
CHECK
SEAT BELT WITH TWO ANCHORING POINTS
- Check the following points:
• Fixing of the anchoring points on the seat.
• Cleanness of the strap and the locking mechanism.
• Triggering of the locking mechanism.
• Condition of the strap (cuts, curled edges).
REELED SEAT BELT WITH TWO ANCHORING POINTS
- Check the points listed above together with the following points:
• The correct winding of the belt.
• Condition of the reel guards.
• The roller locking mechanism by giving the strap a sharp tug.
CLEAN
Do not smoke or approach with a flame during this operation.
Never attempt to carry out welding or any other operation by yourself, as this could cause an explosion or a fire.
- Place the lift truck on level ground with the engine stopped.
- Check any possible leaks in the fuel system and tank.
- In the event of a leak, never carry out any welding or other operation yourself;
contact your dealer.
- Place a container under drain plug 1 and unscrew the plug.
- Remove the filler plug 2 to ensure that the oil is drained properly.
- Rinse out with ten litres of clean diesel through filler port 3.
- Refit and tighten the drain plug 1 (tightening torque 29 to 39 N.m).
- Fill the fuel tank with clean, filtered diesel.
- If necessary, bleed the fuel supply system (
REPLACE
For very dusty atmospheres, there are pre-filtration elements (
AND BELTS).
In very dusty atmospheres, with pre-filtration, the cartridge replacement interval must
be reduced to 250 hours.
Change the cartridge in a clean location, with the engine stopped.
Never operate the lift truck with the air filter removed or damaged.
- Open the engine cover (
INSTRUMENTS).
- Release the locks 1 and remove the cover 2.
ALSO PERFORM THE 500 HOUR PERIODIC MAINTENANCE OPERATIONS.
IMPORTANT
If the seat belt is defective (fixing, locking, cuts, tears, etc.), the lift truck must not be used.
Repair or replace the seat belt immediately.
IMPORTANT
MAINTENANCE: FUEL SUPPLY SYSTEM).
IMPORTANT
2 - DESCRIPTION: CONTROL AND COMMAND
Safety belt
Fuel tank
Dry air filter cartridge
FILTERS, CARTRIDGES
3 - 24
www.duma-rent.com
1
3
2
1
1
2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mc 18-4 d k st3a s1

Table of Contents