GiBiDi TAIMEN T6 Instructions For Installation Manual page 31

TAIMEN
POSITION AND ASSEMBLY CONTROL UNIT-COURTESY LIGHT
Control unit-courtesy light can be installed in three different ways (Fig. 1) .
method A : at the end of the steel drive rail directly on the unit of motor pretensioning and power supply
Ÿ
and Fig.2).
method B: on the ceiling near the unit of motor pretensioning and power supply (Fig. 1-B).
Ÿ
method C: using the cable extension kit, everywhere (Fig. 1-C).
Ÿ
DRIVE RAIL ASSEMBLY
Compose the drive rail joining the three segments
Ÿ
segments are completely put in the junctions.
Put in the assembled drive rail the swinging brackets support (Fig. 3-3) including roundhead screws and nuts.
Ÿ
Put the pretensioning units at the beginning and at the end of the assembled drive rail (Fig. 3-4) and (Fig. 3-6).
Ÿ
Fix the chain to the pretensioners using the included pins ( Fig. 3-5).
Ÿ
Use a 13mm socket wrench to adjust the pretensioning screw until the lower part of the screw head aligns with the
Ÿ
indicator on the pretensioning device ( Fig. 3-7).
WALL BRACKET INSTALLATION
Determine the highest point of the door during the movement and mark the level on the wall above the door
Ÿ
( Fig. 4-1) .
Determine the door center line and mark a vertical line on the wall above the door
Ÿ
Position the wall bracket ( Fig. 4-3) and ensure that the distance between the bracket base and the line previously
Ÿ
marked is not more than 50mm ( Fig. 4-1).
Mark on the wall the position of the two outer screws holes.
Ÿ
Fix the bracket to the wall ( Fig. 4-4).
Ÿ
BRACKET INSTALLATION ON THE DOOR
Fix the handling bracket to a structural part of the door, using the two self-drilling screws 6mm x 50mm. Be sure that
Ÿ
the bracket is on the centre and on the top of the door
FIXING THE OPERATOR TO WALL BRACKET
Important Note: in order to avoid any damage to the operator, it is necessary to put the control unit - courtesy
light on a carton or some protective material
Be sure that the door is closed
Ÿ
Put the assembled operator on the ground
Ÿ
from the door ( Fig. 5-2) .
Lift the operator on the side of pretensioning unit
Ÿ
Fasten the pretensioning unit to the wall bracket using the long pin and a spring clip.
Ÿ
(Fig. 3-2)
( Fig. 4-5)
( Fig. 5-2)
( Fig. 5-1) .
in line with the centre of the door and the control unit-courtesy light far
( Fig. 5-4)
by the two joints (Fig. 3-1), being sure that the drive rail
( Fig. 4-2).
.
.
till the wall bracket ( Fig. 5-4).
31
UK
(Fig. 1-A