GiBiDi TAIMEN T6 Instructions For Installation Manual page 34

34
UK
TRANSMITTERS MANAGEMENT
Learning procedure:
When the operator has stopped, push and release the LEARN button.
Ÿ
appears on the display, the flashing light and courtesy light start blinking slowly.
ŸRL
Push within 6 seconds any button of the transmitter you want to store.
Ÿ
The flashing light and courtesy light will do 3 fast blinkings to confirm that the storage has been completed.
Ÿ
Push within 6 seconds any button of another transmitter to be stoted or wait to go out from the procedure.
Ÿ
Alternative learning procedure:
It is necessary to have a transmitter already stored.
Ÿ
When the operator has stopped, push for 10 seconds the button 1 and 2 of a transmitter already stored.
Ÿ
appears on the display, the flashing light and courtesy light start blinking slowly.
ŸRL
Push within 6 seconds any button of the transmitter you want to store.
Ÿ
The flashing light and courtesy light will do 3 fast blinkings to confirm that the storage has been completed.
Ÿ
Push within 6 seconds any button of another trasmitter to be stored or wait to go out from the procedure.
Ÿ
Complete cancellation of storage transmitters procedure:
When the operator has stopped, push for 8 seconds the LEARN button.
Ÿ
appears on the display, the flashing light and courtesy light start blinking slowly.
ŸRL
The flashing light and courtesy light will do 3 fast blinkings to confirm that the cancellation has been completed.
Ÿ
Release the LEARN button.
Ÿ
Assigning specifical functions to transmitter buttons:
It is possible to assign different functions to the transmitter buttons by setting
TRAVEL LEARNING AND ANTI-CRUSHING THRESHOLDS
During travel learning procedure, the software stores operation times and automatically learns the amperometric
values for the correct operation of the anti-crushing system.
The anti-crushing parameters can be modified later by menu
Travel learning procedure:
When the operator has stopped and blocked, push the button CONFIRM for 5 seconds.
Ÿ
will appear on the display, the flashing light and courtesy light will blink slowly.
ŸLL
Push and release the button CONFIRM or any button of a transmitter stored or enable the input NO.
Ÿ
The operator will do the following learning automatic manoeuvres :
Ÿ
Complete closing in slow down.
§
Complete opening at high speed (menu
§
Complete closing at high speed (menu
§
Complete opening at high speed with slow down (menu
§
Complete closing at high speed with slow down (menu
§
During automatic learning manoeuvres :
Ÿ
Any interaction (photocells, frame, input NO, CONFIRM button) causes the end of the learning procedure that
§
must be repeated from the beginning.
Anti-crushing system is disabled.
§
After the procedure, the flashing light and courtesy light will do 3 fast blinkings to confirm that the learning has
Ÿ
been completed,
any more.
5P
5P
LL
will not appear on the display any more, the flashing light and courtesy light will not blink
AF
.
).
).
5P+5L
).
5P+5L
).
TAIMEN
tr
parameter.